:: Instructions

» Assembly:

1. Screw the 1" (#3) valve with the 8' section hose into the 1" female threaded opening located on the top front of the unit.
2. Attach the 1" aluminum sleeve at the other end of the suction hose to the 3' aluminum wand.
3. Attach suction head to the other end of the aluminum wand.
4. ** Some larger units require the installation of tires and minor parts.**

» Suction Operating Instructions:

1. Roll unit to spill or fluid transfer location.
2. Attach air supply to 1/4" valve (valve #1).
3. Open valves # 2 & #3.
4. Close valve #4.
5. Open air supply valve # 1 completely.
6. Remove aluminum wand from drip tray. Clean-up spill or transfer the fluids desired.
7. When finished, replace aluminum wand to drip tray.
8. Then shut off air intake valve (valve #1).

» Disposal Operating Instructions:

1. Make sure all valves are closed.
2. Pull discharge hose with valve # 4 and hold.
3. Aiming discharge hose toward proper holding container, slightly open air intake valve #1.
4. Adjust air intake valve # 1 until you have the desired flow rate of fluid discharge.
5. When the Spillpro tank is empty, close air intake valve # 1.
6. Close valve # 4 and return discharge hose back to holder over drip tray.
7. Always open valve #2 & #3 and make sure that valves #1 & #4 are closed before leaving machine.
   
   
   
   
   
   US & International patent protected.

WHAT OUR CLIENTS SAY...

The unit has performed well for us so far. In addition to floor cleanups, they have used it for pulling transmission and hydraulic oils, as well as fluids directly from drain pans.

The unit works great when using the larger attachments, but the guys say that it is a little slow when pulling through the smaller tube.

» Guy R. Sundvik