:: Warning

1. When leaving the Spillpro unit unattended, always have valves # 2 & #3 open and valves #1 & #4 closed.
2. Do not aim the discharge hose at anyone. Only at proper containment unit for the liquids recovered.
3. Do not leave tank full or partially full if debris was sucked into unit. Empty immediately to prevent debris from settling to bottom and plugging up unit.
4. Do not restrict air flow from pressure release valve to create more pressure in tank.
5. Do not lean unit lover than level of fluid in unit to prevent fluid from leaking out of muffler.
6. Not recommended for acids (Check with manufacturer for specific needs: stainless or corrosive inhibitors can be custom build for these applications.)
7. Unit will accept JP8 and Diesel fuels. Engine and hydraulic oils.
8. When using for flammable liquids such as: solvents, diesel, of JP8 insure that unit is properly and professionally grounded and ventilated for the application.
9. When attaching ground wire, remove one of the wing nuts on top of the machine, and install eyelet end of wire over threads and tighten wing nut down. Clamp the other end of the ground wire to the proper ground.
10. Minimum #4 flexible copper grounding wire should be used (maximum .001 ohms of resistance on hoses. If more, a separate lead wire should be run along the side of the hose to the source.
11. When recovering flammable/explosive liquids, NEVER smoke, operate near an open flame, electricity or spark producing equipment. Vapors will be produced when intake or discharge of these liquids.
12. After using for flammable liquids, always open valves #2 & #3 when leaving unattended so vapors can escape.
13. Inspect hoses regularly for cracking or other damages.
14. If hoses start loosing flexibility, replace with same.
15. Replace dump hose annually unless sooner needed.
16. Always wear protective eyewear when operating.